I started this time with (again) the , because it’s easy to make and to wear, and the panel version (for ) is a perfect target for weirdnesses such as this:
This particular dress is made out of (I think) four men’s shirts of varying gingham and stripe patterns (I tried really hard to find all different ginghams but ended up with the stripes, which I think worked out okay).
I thought about trying to cut the waistband so that it too would unbutton, but the placket width was slightly off (and I was more than slightly lazy).
But I remembered to take construction pictures this time! So here’s how I cut out that center front skirt panel from the front of a shirt—I extended the front panel to include the curved hem.
Here’s a closeup:
Basically, I created a new pattern piece for the full center front panel (since it’s too hard to put buttons on the fold) and drew a line to mark the CF, which I could then line up over the center of the buttons in the shirt. (I did the same for the CF bodice and CB bodice & skirt pieces [not pictured]).
For the CB, I was able to keep the locker loop and yoke, which I always like (but not enough to go out of my way to sew myself, oh no):
The pocket backing is cut on the bias from the sleeve (men’s shirt sleeves have a lot of fabric in them):
Here it is, constructed:
A little in-progress view of the bodice:
This is right after I resewed the front pocket to overlap the side bodice piece — I usually use to hold the pocket in place while I sew, because otherwise things go badly.
Here’s the full back view:
You can almost see that there’s a shirttail hem on the back, to mimic the one on the front—here’s a closer photo of that:
And the piecing of that, since I couldn’t get the curved hems on the shirts to match up well with the pieces I was cutting. (I actually like how this turned out better …)
I just took the curved hem bits I had left over and eyeballed how they should match the front skirt, like so:
Then it was just a matter of making sure I had seam allowance on the other side, too:
Unless you already have a lot of old men’s shirts lying around, making a shirtdress out of shirts is not that much less expensive than buying yardage (at least not in SF, where a decent shirt at a thrift store will cost you $5-9, depending on condition and whether or not it’s on 50% off sale that day). It takes 4-5 L or XL shirts for one dress, and I try to limit myself to shirts that are unwearable as shirts when I can—ones with stained cuffs, frayed collars, or minor holes that I can work around. I hear tell there’s a that has a ‘pay-by-the-pound’ sale, but I haven’t gone yet—if you’ve gone, feel free to leave your report in the comments!
I want to make a version that is all different flannel plaids for fall, but finding coordinating flannel plaids on intermittent thrift-store trips is a loooooooong project. (It’d would also be fun to make one in Hawaiian-shirt prints, or one in novelty prints … )